104 LED bulbs.
The LED bulbs never need replacing.
LED's illuminate cool to the touch and never get hot. They are therefore safer than electric light bulbs.
Select a set for your desired color choice.
Sets available as all white, OR, multi-color (green, blue, amber & red).
Several selectable lighting modes/programs.
Modes include flashing, continuous, alternating, twinkling etc.
Built-in photocell ensures automatic operation at night time only.
The LED bulbs remain absolutely cool to the touch and never get warm or hot like conventional string lights, making them much safer to use and operate.
Very easy to install, no electricity required.
High quality Crystalline solar cell panel.
The color (color temperature) of the white LED bulbs are approx. 5000k for a brilliant white light output.
Solar cell is built into the front of the control panel for outdoor installation.
Integral 6 volt 4 A/hr rechargeable battery (included) housed inside the controller.
The battery is a sealed lead acid battery is replaceable (recommended every 2-3 years or so) when necessary.
Battery is housed inside (ABS construction) weatherproof controller.
Illumination time is typically dusk to dawn.
A 6" (15cm) pole and a 4" (9cm) ground spike is included.
Light output is not a bright as conventional electric light bulbs therefore best installed in dark locations for better effects.
Approximately 37' (11 metres) of LED lights on green cable.
Lead in (length of wire to first LED bulb) is approximately 6' (2 metres).
Each LED bulb is spaced approximately 4" (10cm) apart.
Dimensions of control panel are approximately 7" x 4" x 2.5" (18cm x 11cm x 6cm) LxWxD.
Solar powered string lights are not inter-connectable and not joinable for obvious reasons.
The battery is recharged every day from sunlight and is typically enough to allow the lights to illuminate from dusk to dawn in most locations.
If the battery is ever allowed to completely discharge, then it can take several days to fully recharge. This could happen if stored and left switched on. However with normal daily charging and use, a total discharge situation is not possible.
If stored for long periods of time, we recommend that the fixture is switched off and the battery is allowed to full charge from time-to-time with full sun exposure to ensure a good battery charge (float) level and to prevent deep discharge, while stored.
Time length of night time illumination is estimated and subject to various factors including geographic location, seasons, weather conditions & location of product etc.
Shorter illumination time due to one or more of the above factors does not define the fixture as being defective or define the fixture as being advertised incorrectly.
We advertise and supply our solar lights to customers all over the world are therefore, naturally, we are unable to guarantee the nightly illumination time as it can vary and any time stated is quoted as 'up to' x amount hours.
Minor errors & omissions must be accepted.
Although unlikely, we reserve the right to supply this product with any minor alterations or minor changes to the specifications (shown above by text description or by photographs) due to different supplies or product batches received, incorporating such product changes made by the manufacturer, without further notice.
Descriptions, specifications and photographs are updated regularly but may not be current when minor changes to a product have only recently been made.
All solar lights must be used in a completely dark location at night time otherwise they may not illuminate. Nearby strong lighting sources or ambient lighting may affect the operation of a solar light. This does not define the fixture as being defective.
NOTE: This product is a festive item and is non-returnable unless in the event of a warranty claim after which, when verified, will be repaired or replaced only. All sales are final on this item.
NO REFUNDS (UNLESS PRODUCT IS DEFECTIVE DURING ITS WARRANTY PERIOD AND IT WILL BE REPAIRED OR REPLACED ONLY). NO EXCEPTIONS. ALL SALES ARE FINAL ON THIS PRODUCT.
The control box has two switches. One switch is the auto/mode switch. The other switch is the on/off switch.
Instructions are supplied with this fixture, which is very simple to operate. Both switches must be in the off (O) position before use.
The mode/auto switch must be turned to the on (I) position first, BEFORE turning the on/off switch to the on (I) position.
If this procedure is not followed correctly, then the LED bulbs will not illuminate because the mode switch has to be switched on (I) BEFORE the on/off switch is switched on (I).
Should the user fail to follow the operating instructions correctly, this does not define the fixture to be defective. This would be 'user' error only.
Following the instructions supplied and notes above, the fixture will operate normally as it is designed to do.