PL10 Solar 'Windsor' Post / Pole Top Light (Round Base)
PL10 Solar 'Windsor' Post / Pole Top Light (Round Base)
TECHNICAL SPECIFICATIONS

Up to 12 hours illumination at night.
Typically dusk to dawn illumination.
Up to 3 days reserve (autonomy) power to allow for cloudy days.
All aluminum construction.
Commercial grade quality.
Matt black powder coated finish.
Lampshade with round base (collar) to fit a 3" diameter round post or round pole.
Installation is easy. The lampshade simply slides over the top of an existing pole or post.
Holes are pre-drilled in the round base (collar).
Simply screw or bolt through the round base (collar) and through into your existing pole or post. (Screws/bolts not included).
Installation should take only a few minutes.
For use with an existing round pole or round post. A round pole or round post is not included with the fixture.
When fixing to an existing round pole or round post the top must be no bigger than OD 3" (76mm).
66 super bright LED bulbs.
The LED's provide a warm white illumination color.
LED's are arranged onto an E27 screw-in bulb unit providing an uniform 360 degree lighting pattern. The E27 unit is replaceable.
LED color temperature is 3500k. Alternative E27 units (with different color temperatures) are available by special order only and for very large quantity orders only.
Each LED provides 6 Lumens, about 400 Lumens total output.
Equivalent to a conventional (incandescent) 75 watt light bulb.
Three, high quality, 7 watt solar panels discretely built flush into the top of the fixture.
One solar panel is fitted on 3 out of 4 sides.
Installation of the lampshade would set so as to orientate each of the solar panels to face East, South and West.
The fourth side would face North and does not require a solar panel.
Total solar panel wattage is 21 watts.
The solar panels are monocrystaline or polycrystaline.
Electronic circuit board (PCB) is housed within the top of the lampshade.
All PCB connections are plug & play.
The PCB is conformally coated for added weather/humidity resistance.
A 12 volt 12 Amp/Hour sealed GEL rechargeable battery is supplied and located within the top of the lampshade.
The battery is replaceable, usually every 2-3 years and is accessed quickly and simply by a removable panel on the top of the lampshade.
The battery has a working temperature to as low as -40 deg F (-40 deg C) and to as high as +122 deg F (+50 deg C).
Higher specification battery of the same voltage and ampage can be used, for more extreme environments, or where required.
Built-in photocell for automatic dusk-to-dawn operation.
On/off switch for manual over-ride.
The clear glass lampshade has 4 glass panels, each toughened and tempered.
The glass sections are 1/5" inch (5mm) thick.
The internal diameter (ID) of the round base (collar) of this fixture is approximately 3 1/10" (78mm).
This fixture is approximately 23" (58cm) high x 18" (46cm) x 18" (46cm).
Weight of complete fixture is approximately 55 lbs.
This fixture does not include a post or a pole. It is designed to attach to a new or existing post or pole.
One year limited warranty.
This product is defined as a 'special order' and our special order terms apply.
This light fixture requires several hours of full sunshine daily to enable it to get a full charge in optimum conditions and in an optimum geographic location.
Time length of night time illumination is estimated and subject to various factors including geographic location, seasons, weather conditions & location of product etc.
Shorter illumination time due to one or more of the above factors does not define the fixture as being defective or define the fixture as being advertised incorrectly.
We advertise and supply our solar lights to customers all over the world are therefore, naturally, we are unable to guarantee the nightly illumination time as it can vary and any time stated is quoted as 'up to' x amount hours.
Minor errors & omissions must be accepted.
Although unlikely, we reserve the right to supply this product with any minor alterations or minor changes to the specifications (shown above by text description or by photographs) due to different supplies or product batches received, incorporating such product changes made by the manufacturer, without further notice.
Descriptions, specifications and photographs are updated regularly but may not be current when minor changes to a product have only recently been made.
All solar lights must be used in a completely dark location at night time otherwise they may not illuminate. Nearby strong lighting sources or ambient lighting may affect the operation of a solar light. This does not define the fixture as being defective or 'not as described'.
Naturally, the illumination duration (light-up time) of most solar lights can reduce during winter months when the weather is poor and the days are shorter. During this time insolation hours decrease accordingly. This does not define the fixture as being defective or 'not as described'.